Polished stainless steel pressing plates for laminating applications. (Picture shows all 3 different sizes available).
Used with Pellet Presses to form the pellets for use in IR and x-ray spectroscopy. The stainless steel die includes a fitting for vacuum source connection. (6, 12, 13, 25, 31 and 40mm dies available.) Not recommended for use in heated presses.
Consult factory for special test cylinder sizes. For molding, forming bricks, briquettes, pressure forming, crushing, pressing plant and animal tissues, fluid extraction, extrusion and flow tests. Note: For use in Carver standard presses (excluding pellet presses) Not recommended for use in heated presses.
A pack of 12 filter pads for the two test cylinders outfits we offer.
Recommended for use with pellet dies and test cylinder outfits. Picture shows #5021 installed in our Model C 3851 press.
Vacuum pump #3874
Used with pellet presses to remove gases from pellet dies. Pump includes: Vacuum gauge and Connecting tubing. Available in 115V or 230V. (please specify)
No. 5456 Proppant Crush Test Cylinder
This die is designed to test proppant used in the hydraulic fracturing process. Based on ISO 13503-2:2006(E) Crush Cell.
Cell: 2″ ID x 3.38″ tall including removable base, wall thickness is >0.5″
Piston: 3.5″ tall
All parts constructed of D2 Tool Steel, hardened to 52-56 Rockwell C
No. 2092 Swivel Bearing Plate
Carver presses are frequently used for crushing and breaking tests of standard 2″ x 2″ cubes and 2″ x 4″ cylinders of concrete samples or similar crushing tests. Swivel Bearing Plates adjust slightly to the sample to assure proper application of pressure. For unheated models only. Requires safety shield.
No. 818744C Pharmaceutical Punch and Die Holder
This punch and die holder permits testing of pellet and tablet samples. It works with standard BB2 type tooling in most Carver presses, including Auto Series presses. The set includes an anodized aluminum holding fixture, steel shims to adjust for various size samples, and an anodized aluminum ejector. Minimum daylight required, 11-1/2″. (Does not include dies) Not recommended for use in heated presses.
No. 2095 KBr Buffer Plate
Required for use with pellet dies. The 90mm diameter plate mounts to top bolster to prevent damage by the die plunger during pressing.
No. 237005 Stainless Steel Pan
Fluid pan for use with Test Cylinder Outfits.The stainless steel pan captures the release fluid. Also included with purchase of unheated Test Cylinder Outfits.